How do you reset the power door on a Toyota Sienna?

How to Reset the Power Door Battery on a Toyota Sienna

1. Press the sliding door control button on the Sienna's dashboard so that the red line on the button is illuminated.
2. Raise the hood of the van, and disconnect the negative ("-") battery cable with a wrench.
3. Press the "Open" button on the remote key fob to open the sliding doors.
4. Close the door, and wait 10 seconds.

.

In respect to this, how do you fix a sliding door on a Toyota Sienna?

Replacing Your Sienna Slide Door Cable Assembly

1. Take out the seat closest to the defective sliding door.
2. Roll down the window on the defective door.
3. On the side of the door is a hex screw holding the plastic panel in place.
4. Slide the lock back into the door, in the unlock position.
5. Gently pry off the plastic panel.

Furthermore, how much does it cost to fix a Toyota Sienna sliding door? The average cost for a Toyota Sienna power sliding door motor replacement is between $3,875 and $3,904. Labor costs are estimated between $105 and $134 while parts are priced at $3770. Estimate does not include taxes and fees.

People also ask, how do you unlock a Toyota Sienna door?

To unlock the door, slip your fingers behind one of the front door handles and touch the inside surface. The door will unlock automatically and you'll hear two beeps. To lock the doors, make sure they're all closed, then touch the two grooves on top of the front door handle. You should hear a single beep.

How do you lubricate a Toyota Sienna sliding glass door?

The first step is to get a hold of some silicone spray, like this stuff for example. Open the sliding door and locate the bearing near the bottom. Take a rag and wipe out as much dust dirt and debris as you can from the track. Once the track is cleaned out, take the silicone spray and spray the bearings.

Related Question Answers

How do you take the door panel off a Toyota Sienna?

How To Remove Front Door Panel 04-10 Toyota Sienna

1. Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver.
2. Pry off the door handle bezel with a flat blade screwdriver.
3. Remove the Phillips screw in the door handle.
4. Remove the Phillips screw in the door pull.
5. Remove the Phillips screw beneath the arm rest.

Is there a recall on Toyota Sienna?

TOYOTA IS RECALLING CERTAIN MODEL YEAR 2011 THROUGH 2012 SIENNA VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 110, "TIRE SELECTIONS AND RIMS."