Unplug the power cord from the wall outlet. Unscrew the timer knob and remove it. Pull the timer dial up and off the timer stem. Pull the plastic end caps off the sides of the control console..
Also know, how do I test the timer on my Kenmore washing machine?
Touch the two probes of the volt-ohm meter to the contact points to be tested. Turn the dial of the timer to the appropriate cycle that is being tested. There should be no continuity reading on the volt-ohm meter during the test. If there is a reading on the volt-ohm meter, the timer is faulty.
Subsequently, question is, why is my washer not changing cycles? If your washer does not advance through the cycle or stalls at a wash or rinse fill portion, then the water inlet valve may be at fault. You should first verify that the inlet hoses do not have any kinks or restrictions and that the inlet screens are clean.
Furthermore, how do you remove the control panel from a Kenmore washer?
Remove/Replace Control Panel on Kenmore Washing Machine
- find the end covers (usually plastic)on each side of the control panel.
- with a small screwdriver, gently pry the bottom of the covers forward and up.
- under that cover you will notice a small screw that holds the panel to the top of the washer.
Why does my washer get stuck on the wash cycle?
If the drain control is broken or the drain is clogged, the washing water won't be able to escape and the washing machine will stall trying to start the rinse cycle. You may be able to clean and readjust your drain control components, or you may have to replace them entirely so they can start functioning again.
Related Question Answers
How does a washing machine timer work?
A washer's timer will generally allow the washer to fill with water while the lid is open; however, most new washers will not allow any mechanical functions while the lid switch is open. Some older models will allow agitation, but no washing machines should spin with the lid open or a broken lid switch.How do I reset my washing machine?
To perform the Master Reset, carefully unplug the washing machine from the power outlet and leave it unplugged for one minute. After one minute is up, plug the washer cord back into the wall. Next, open and close the door of the washing machine 6 times within 12 seconds to send a “reset” signal to all the components.How much does it cost to fix a washing machine?
Some put the average washing machine repair price range at anywhere from $51 to $350, while others (including one of our top competitors) say repairs will run you a minimum of $200.How much does a dryer timer cost?
Faulty dryer: This could be due to lack of power or a bad timer, thermostat, terminal block or start switch. Check each and replace as needed. The cost to replace a thermostat can run you between $100 - $200 Cost: $50 - $1,000.What does delay timer mean on washing machine?
The delay start timer can be set to activate a pre-arranged cycle while you're in bed, at work or running errands. Basically, if you need to your washing machine to run a cycle but won't be a home to do it then the delay timer can be used to do it for you. 
